Selection of mechanical vapor compressor seals
Thread Content
The most common problem with compressors is leakage from the high-speed shaft seals. Our factory uses both labyrinth seals and carbon ring seals; since centrifugal compressors typically operate at speeds of over 20,000 revolutions per minute, the high speed makes it easy for these seals to wear out and cause leakage. Friends, please share how the compressors in your factories are performing. Everyone discusses with each other to improve.
Gas film sealing is similar to dry gas sealing, and Dongying Haisen produces it quite frequently
A steam seal cooler can be considered to create a slight negative pressure at the seal site, thereby eliminating the phenomenon of white smoke
If ordinary carbon ring seals don’t work, should one try dry gas seals then?
Dry gas? Whether it’s compressed air or nitrogen, the leakage issue needs to be taken into consideration.
So what are you worrying about? The gap is ensured; there might be some leaks