How is the tilting-pad bearing of Shenyang Blower Group’s centrifugal compressors lubricated?

The tilting pad bearings in Shenmu centrifugal compressors generally have two lubrication methods: immersion type and direct supply type. 1. **Submerged lubrication**: In this method, the bearing is partially or completely submerged in an oil pool, and the lubricating oil in the pool is lifted by the rotation of the bearing to form an oil film. Lubricating oil is brought to the contact surface through the rotation of the bearing itself, and it is suitable for bearings that are not subject to particularly high speeds or loads. 2. **Direct supply lubrication**: In this method, oil is pumped directly to the lubrication points of the bearings through an oil station. This method allows for more precise control over the oil flow rate and pressure; it is particularly suitable for bearing lubrication under high-speed and high-load conditions. The differences in lubricant filling inside bearings lie mainly in the following: Submersion lubrication relies on the physical relationship between the oil reservoir and the bearing, as well as the rotation of the bearing, to supply oil automatically. - In the direct supply type, oil is supplied directly to the surface of the shaft by external force (such as an oil pump), allowing for a more effective and stable control of the lubrication condition; it is particularly suitable for high-load and high-speed operating environments. As for the drawings, I am unable to provide directly the specific drawings of the bearing lubrication system for Shenyang Blower Group’s centrifugal compressors; it is recommended to contact Shenyang Blower Group Co., Ltd. or its official representatives to obtain detailed technical information and support. They can provide detailed technical drawings and further technical support. .