How to adjust the dead center position of the eccentric bearing in a spring-vibrated fluidized bed
Thread Content
Today, when starting the spring vibration fluidized bed, the initial problem was belt slippage. After having a blacksmith adjust the wheel spacing and trying to start the machine again, the pulley could be forced to rotate, but it did so with considerable difficulty. After a few rotations, the driven pulley came to a stop at its dead center position, and the driving pulley also stopped; subsequently, the power supply was cut off. It is very difficult to turn the shaft manually. Why does this phenomenon occur, and how should it be dealt with?
Check if the bearing is lacking oil Is it entering the dust? Are the gaps between various components appropriate?
Check if the material is seated properly Check if the bearing is lacking oil