Such a message appears when reinforcing the SW6 opening
Thread Content
**********Calculation results for opening reinforcement********** Incorrect input data: Pipe end = Data name=
What specific parameters did the original poster enter?
It’s not clear what’s going on; it would be best to send screenshots of the data entry interface and the prompt interface.
Please reopen the software and enter the data carefully...
This message appears either because the count wasn’t lost or because the takeover thickness is insufficient
I also received this error message; after adding the nominal thickness for the takeover, I was able to perform the calculations normally.
I’ve encountered this before; check to see if a parameter was entered incorrectly or not filled in completely
It seems that the thickness for takeover wasn’t entered, so it is calculated as 0. Incorrect.