deaerator
2017-05-27View Original
Thread Content
Must the design pressure of the deaerator tank be the same as that of the deaeration head?Reply #22017-05-27
It should be the same; it’s not two separate chambers after all...
Related Threads in This Forum
← Previous
- Is it necessary to redo the lining around the new openings i
- Who is responsible for reviewing the welding process? - HCBB
- Is it necessary to perform flaw detection on the furnace flu
- Angle steel flanges for differential pressure vessels - HCBB
- Selection Guide for Enameled Steel Products (such as Enamele
- Rolling process - HCBBS Forum
- What are the measures to reduce local stress? - HCBBS Forum
- Issues regarding the addition of reinforcement rings to exte
- The relationship between welding speed and weld quality - HC
- On the design of fittings with jackets - HCBBS Forum
Next →
- Common **standard, industry standard, and local standard fre
- Wall thickness of pipe suitable for welding in welder projec
- In the pressure vessel regulations, are all the media in the
- Little knowledge about pipe expansion joints - HCBBS Forum
- One question per day; no prize for correct answers, it’s jus
- The air-cooled tube bank in the PID drawings is installed wi
- Welding knowledge – “Yield strength”” - HCBBS Forum
- I would like to ask what causes a loud roaring sound from th
- What is equipment technical condition management? - HCBBS Fo
- Steam energy saving------Selection of steam traps - HCBBS Fo
Translated at 2026-07-21 03:06:32
Original: https://bbs.hcbbs.com/thread-1783646-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.