Regarding reinforced flat plates
Thread Content
The flat cover plate has thin spots; I want to add grid-like ribs on it. We need to carry out calculations and make the necessary arrangements for this. Could someone with experience please give me some guidance and outline the steps to follow?
Take a look; 150 is written in quite some detail now
Calculation of the thickness of reinforced circular flat covers per GB150 P142. . . . I won’t say too much; you can take a look~
How much pressure is it? Load? The original poster can share the parameters so I can take a look; otherwise, it’s likely that you won’t find the answer you’re looking for in the replies to this post. On the forum, requests for help need to be clear and specific, so that those who read the question can provide targeted responses. For example, there was once a post asking, \"What aspects should be considered in pressure vessel design?\" ”This question is obviously absurd and makes one laugh and cry at the same time – it’s hard to know how to reply, right?
HG2059x, six-in-one, with flat cover equipped with reinforcing ribs for calculation
SW6-2011 v3.1 includes the calculation for \"round flat covers reinforced with gussets\" in its component calculations.