A problem was found with the standard plate lugs on the top of the equipment
Thread Content
This post was last edited by lucyghb on 2017-11-30 at 13:20. With this 20-degree angle, the line inside the red line will extend beyond the backing plate; how did you solve this issue?
This is a standard error; our company increases the size of the shims.
Well, I didn’t pay close enough attention to the details; the riveter on site followed the standard drawings and ended up cutting off the cushion plate directly
Basically, it is considered to use larger shims; since such lugs are usually used for small equipment, the problem is not serious