Calculation of SW6 cone head
Thread Content
Diameter 2500, pressure -0.1 MPa, temperature 100°C, material: 304. How to calculate the conical head? Could someone experienced give some guidance?
The last edit to this post was made by zghzlj on 2018-7-2 at 14:06. Are the nominal thickness of the head, the nominal thickness of the large-end cylinder, and the nominal thickness of the small-end cylinder entered manually or calculated automatically by the software?
Enter the value first, check the calculation sheet; adjust it if it’s not appropriate – don’t leave it blank.
Can it be calculated without entering any values? Why do I keep getting error messages?
The thickness value cannot be left blank; enter a value and then make the correction. First, fill in according to my example and run the calculation.
Actually, the thickness field can be left blank; the software will calculate it automatically and fill in the value
Actually, the thickness field can be left blank; the software will calculate it automatically and fill in the value