Water wash
Thread Content
Why should the cross-sectional area of the flushing discharge pipe not be less than 60% of the cross-sectional area of the pipe being flushed during water flushing?
What matters is the flow rate of water at the area to be washed. If you increase the flow rate in the discharge pipe, the flow rate inside will be lower than that in the outlet pipe, and thus the internal flow rate will decrease.
Does a larger area of the flush discharge pipe result in a lower flow rate? Shouldn’t a larger exhaust pipe area result in more flow and faster flow rates? \ud83d\ude0a
Oh, I’m sorry, I didn’t understand your question. I’m not sure what special features your equipment’s piping system has. I'm sorry.
This post was last edited by zjq1962 on 2018-11-10 09:39. I’m not sure where the flushing pipe mentioned by the original poster is located It is certain that, with a constant flow rate, the flow velocity is inversely proportional to the cross-sectional area of the pipe.