The circulating cooling water interfaces of each layer of the glass-lined plate condenser are connected with U-shaped rubber tubes
Thread Content
This post was last edited by jmdc on 2019-1-4 15:17. The circulating cooling water interfaces of each layer of the glass-lined plate condenser are connected with U-shaped rubber pipes. The U-shaped rubber pipes are tied with cable ties on the interfaces of the equipment body. However, the pressure of circulating water is generally more than 4 kg. What should I do if the cable ties are easy to loosen and often cause the rubber pipe to fall off?
Cut a groove at the interface and tie it tightly with a tie.
This is a soft connection, and there are also rigid connection structures.
Do you think how to cut grooves in this interface?
There is still gasket leakage between each layer and may need to be replaced. The two interfaces cannot be connected and must be connected loosely and removably.
Rigid connection does not mean a welded structure, but it does not use a hose connection as the poster mentioned.
Or just make the interface threaded and connect it with a union.
There are usually valves and pressure gauges before circulating water enters the condenser to adjust the inlet water pressure.
There are advanced connection methods, but the cost is too high.