Regarding the nominal thickness of forged pipes in pressure vessels
Thread Content
Should I enter A or B in SW6?
Enter the thickness of B, and select the thick section of B for the extended length. Generally, reinforcement will not be involved after it exceeds a certain length.
This post was last edited by zjq1962 on 2019-1-23 14:43 The lower end is connected to the shell, and the upper end is generally connected to the flange. The reinforcement calculation is of course based on the thickness of B. At this time, the input outer diameter of the nozzle is not 32.
Yes, I understand. Entering 32 is to determine the value of the flange wall thickness in 20592.
The overhanging height must be the height of the thicker section, otherwise the area of A2 may be overcalculated.