[Discussion Thread 62] How to determine the length marked in red in the rib support diagram?
Thread Content
The last edit to this post was made by kareale88 on 2019-5-14 at 19:12; file bg4.png was edited. [Discussion Thread 62] How should the lengths marked in red in the steel plate support diagram be determined? As shown in the image
Made on-site, usually 1/2 B
It can be stated that it will be designed according to the on-site conditions, but before production, when detailed drawings for this part are prepared or questions arise in the workshop, there should also be theoretical values available. :D
There are no strict rules; it’s fine if you cut it at an angle, as long as it looks good.