SW6-2011 V4.0 expansion joint calculation questions
Thread Content
Please ask my colleagues~! Now that SW6-2011 has been upgraded to version 4.0, how do I choose the parameters in the red box? Also, when calculating the expansion joint in the past, the total axial displacement of the expansion joint was automatically entered on the expansion joint page after calculating the tube plate. However, this data is not available when calculating the expansion joint now. How to calculate the expansion joint of the current version SW6? Please give me some advice~! !
SW6-2011v4.0 new and modified content description
Yield strength on quality certificate? Where can I find the quality certificate?
You don’t understand the meaning of these four parameters! Then you haven’t learned expansion joint design, right? Software is just a tool, and you have to understand the entire design process to use it.
Yes·I haven’t seen the new version of expansion joint yet
Buying an expansion joint requires a supervisory inspection certificate and a certificate of conformity
The key question is how can there be a supervisory inspection certificate during the design stage? Do we need to buy the expansion joint first and then perform design calculations? If the calculation fails, what should I do with the purchased expansion joint?
Why does the 2018 expansion joint formation calculation book calculated using SW6-2011V4.0 have so many pages? ? I wonder if any of you have encountered similar problems. I checked them out. There are too many repetitions.:
In fact, there is no duplication. It is just calculated whether the strength of the expansion joint is qualified under many different working conditions.
I asked a technical engineer from an expansion joint manufacturer and he said that the last one in the red box should be chosen.