Strength calculation of stainless steel mixing storage tanks with flat lids and inclined bottoms
Thread Content
I need help with the strength calculation for stainless steel mixing and storage tanks with flat tops and inclined bottoms. Does anyone have the necessary calculation software, or which software should be used for this purpose?
It’s a flat-top cone bottom, use SW6.
Based on the inclined-bottom reinforcement structure, it can be calculated using the corresponding flat plate deflection formula.
Thank you for your reply! For some reason, the system didn’t send me a reminder for your reply; I just saw it today. It has a flat lid with an inclined bottom, not a conical bottom.
Thank you for your reply! For some reason, the system didn’t send me a reminder for your reply; I just saw it today.
Are you referring to the need to ensure complete drainage, with that slight slope? If so, it wasn’t taken into account during the design.
Yes, the inclination was increased in order to drain it completely. Don’t we need to consider strength calculations? Grille supports have been added at the bottom due to the inclination of the tank floor.