3D modeling of jacketed containers
Thread Content
Dear all**, I’m not very familiar with jacketed vessels; could you please help me out? Can the jacket head and the inner cylinder head be connected in this way? ? ? Can it be placed right next to the nest? There’s another question: how do I model this fold? ? I have no idea at all (UG software). Please give some advice, thanks! ! !
This post was last edited by wanlirn on 2020-4-14 at 16:48. It’s possible to fold the edges directly, but there are several outlets here, which is unreasonable. Even if such a requirement exists, it would be better to create a larger opening and connect a tee fitting at the bottom. The CAD drawing you’ve made seems to be the work of an amateur; I don’t know UG. This was created using Creo after scanning
It has multiple material discharge ports; it’s not easy to handle this, with one rotation only
Take a look at page 309 of GB/T150, the structure of the jacket seal
I personally recommend not doing this; it’s too difficult
You can first stretch the straight edges and then round them off