NB/T47065.5-2018 selection-related questions

2021-12-22View Original

Thread Content

This post was last edited by wx_Catherine_Mi on 2021-12-26 at 13:46. Recently, while studying NB/T47065.5-2018, I noticed that the height-to-diameter ratio of the devices is quite high; the dimensions of the rigid ring mounts specified are also large. However, the allowable vertical load and allowable bending moment seem to be relatively low. I would like to ask: 1. Does the value mentioned here refer to a single rigid ring mount? 2. The standard specifies W≤, but in the SW6 calculation it is Fb≤ that needs to be verified – which one should take precedence? I took another close look: 1. It’s not a single one ； 2. SW6 is incorrect; it should be W≤. SW6 V5.0 will have modifications.

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

NB/T47065.5-2018 selection-related questions

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links