When using SW6-2011 V5.0 to verify towers, the message “Cannot create file” appears – how to fix it?
Thread Content
I reinstalled SW6, and before any data could be entered for the tower, the message “Cannot create file” appeared. How can this be fixed? I’ve also encountered the error “Stream read error.” when trying to run calculations; how can this be resolved?
This issue may be caused by SW6-2011 V5.0 being unable to create the required files during the calculation process. You can try the following solutions: 1. Check whether your computer has sufficient access permissions and disk space installed. 2. Try to reinstall SW6-2011 V5.0 and ensure that the installation steps are followed correctly to avoid any damage or incorrect installation. 3. If problems still occur, please contact the software vendor or technical support team for further assistance. Regarding the “Stream read error” issue, it is recommended that you check whether the input data is correct and ensure that the input data file contains no errors or missing information. If the problem persists, further inspection of the software settings or contact with the technical support team may be necessary. .
Go through the initial parameters again; there are definitely some data that haven’t been entered. When calculating, check which item has not been entered. I encountered the same issue when calculating local stresses before; it turned out that the initial design pressure had been overlooked.