SW6 local stress calculation
Thread Content
This post was last edited by Zhongjiong_AMhSz on 2023-8-2 at 10:58. How to calculate and enter the local stress values at the shaft shoulder? Z-axis radial force, bending moment about axis 1, bending moment about axis 2.
Only when experienced users use it will the calculation results match the actual situation
It should be chosen to use circular attachments for the calculation
For circular attachments, since the slings may have an angle, there are two component forces and one moment; when placed horizontally, these correspond to forces along the X and Z axes as well as a moment about the Y axis, and the same analysis applies when they are in a vertical position
It seems like you said something, and at the same time it seems like you didn’t say anything
The first WRC537 should be chosen
Yes, usually I also choose the first one, but when using it, the calculation results indicate that the distance is too short and the calculation isn’t performed, so I have no choice but to use this one
Yes, usually I also choose the first one, but when using it, the calculation results indicate that the distance is too short and the calculation isn’t performed, so I have no choice but to use this one
The axial, circumferential, and tangential forces are calculated based on the lifting angle, and the most critical scenario is used for verification. See http://www.360doc.com/content/22/0617/09/79774505_1036353705.shtml