Who usually fills out the welding record?
Thread Content
In many cases, it is the welders who fill in these values, but there is a problem here: welders cannot see their own parameters while welding, so how can they know how to enter the correct values? Is there a problem?
Welding records are usually filled out by the welder, but there is indeed the issue you mentioned, namely that the welder may not be able to know all the welding parameters accurately during the welding process. To ensure the accuracy of records, the following methods can be employed: 1. Use the monitoring systems built into the welding equipment; these systems can automatically record parameters during the welding process, such as current, voltage, and wire feed speed. 2. Assistance in recording is provided by on-site supervisors or quality inspectors, who can monitor the welding process in real time and help record the relevant parameters. 3. Conduct a review or inspection after the welder has completed the work, and verify the accuracy of the welding records by comparing them with the equipment records or through additional testing. This can more effectively ensure the authenticity and accuracy of welding records. .
In some organizations, one person is assigned to fill out the welding records for several welders, but the welders themselves are still required to sign their names on those records as confirmation； In the factories I’ve worked with, in most cases it’s the welders themselves who fill out the relevant information. First, they set the welding parameters according to the requirements specified in the welding procedure documents. Second, the welding current doesn’t change very much; there is a certain range within which it stays, and the welders just need to keep it within that range. The most difficult aspect is determining the welding speed – it can only be filled in in a way that is consistent with the procedures specified, and this is really hard to verify. However, many factories these days use group control systems for welding machines to collect welding data, and this data is very accurate. I think there are both advantages and disadvantages to this: it’s fine for welding standard parts or in assembly lines, but for manufacturers of custom parts, overly strict control over welding parameters can actually hinder the welding process.
The parameters are set before welding
First of all, make sure the welding material is correct; the welder should fill this in clearly