Calculation of the radial swing amount at the free end of the stirring shaft cantilever
Thread Content
When the mixing equipment is undergoing static shaft turning, the radial swing of the free end of the mixing shaft’s cantilever shall not exceed the value calculated using the following formula. When there are special requirements, they should be specified in the design documents. δ=0.0025Ln-1/3 δ=0.0005L. Where: δ – radial oscillation amount (mm); L – length of the shaft’s cantilever section (mm); n – rotation speed of the stirring shaft (r/min). The radial swing of the free end of the stirring shaft’s cantilever shall not exceed the allowable value specified in the design drawings, which is determined based on the requirements of the chemical processing procedures or equipment design (such as preventing the stirrer blade from scraping the tank walls, or using stirrers with scrapers).
“δ=0.0025Ln-1/3 δ=0.0005L”? I don’t understand the formula
I don’t understand the formula: δ=0.0025Ln-1/3; δ=0.0005L. What is the value of n?