The issue of the inner diameter of the heat exchanger nozzles
Thread Content
This post was last edited by EatTigersCat on 2017-1-17 at 10:43. Are there any relevant standards that specify or standardize the inner diameter of the inlet and outlet nozzles on the tube side or shell side of heat exchangers?
These were determined by the process engineers, taking flow rates into account; for the equipment, the computing load is sufficient, so there are generally no issues.
Yeah, that’s right. I’m a craftsperson. . . .
Then you can just calculate the approximate inner diameter based on the flow rate requirements and then select the appropriate nominal pipe size.