Thread Content
To understand the production and assembly process of a detachable plate heat exchanger, the first thing to do is to understand its components. Generally speaking, it mainly consists of fixed compression plate, movable compression plate, upper guide rod, lower guide rod, heat exchange plate, sealing strip, pillar, etc. The production and assembly process of detachable plate heat exchangers is different for each company. Our standard production and assembly process is as follows: first step: Plate heat exchanger plates, strips, frames and parts are produced and shipped to the warehouse after passing production. Step 2: Assembly task order breakdown. Step 3: Parts are shipped out of the warehouse and inspected to pass the inspection. Step 4: The frame assembly is qualified and the plate hanging pads are qualified. Step 5: The sixth step of hanging the film: The seventh step of screw protection tube: The eighth step of plate compression: The ninth step to pass the air pressure test: Nameplate identification step ten: Factory inspection may seem like ten simple steps, but in fact each step requires rigorous treatment. If you are not careful, problems will occur, affecting heat exchange efficiency and even production. Our production and assembly workers have more than ten years of experience in plate heat exchanger work, which can ensure the smooth progress of every assembly link. At the same time, they can also ensure high efficiency and a short delivery period.