There is vibration in the inlet and outlet tube bundle areas of the heat exchanger
Thread Content
As shown in the figure below, there is vibration in the inlet and outlet tube bundle areas of the heat exchanger. How should this be adjusted? The diameter of the heat exchanger is already close to 2 meters, and even by increasing the pipe diameter, it’s not possible to eliminate this vibration. Do any of you have any other suggestions?
Let’s use our type instead – heat exchangers with spiral-coiled tubes. They are very small in size, light in weight, and easy to install. The one you’re using is likely more than 10 times larger than ours.
Let’s use our type instead – heat exchangers with spiral-coiled tubes. They are very small in size, light in weight, and easy to install. The one you’re using is likely more than 10 times larger than ours.
Fully polished, made of stainless steel