Problems with HTRI
Thread Content
Water vapor on the shell side condenses; when selecting materials, should one simply use the water data from the property table? It’s better to look up the tables and enter the physical property parameters yourself
Should condensation be considered during the design?
After making the selection, do the parameters in the condensation interface need to be set?
It is necessary to enter information such as temperature, vaporization rate, as well as flow rate and pressure
Weren’t these basic parameters entered from the start?
No matter when it’s entered, as long as it can run, that’s fine
Why does it work sometimes when I type it, but give an error other times? . Is it because of piracy? .
Generally, just enter the values for the input conditions that are marked with a red box; without any other descriptions, I can’t determine anything else
If the medium is water, it’s usually sufficient to use the property database built into HTRI, as the properties of this common and relatively simple medium don’t vary much