Calculation of expansion joints for fixed-tube-sheet heat exchangers
Thread Content
This post was last edited by cxd11888 on 2018-6-16 05:42. Dear colleagues: Have you encountered situations where, after calculation, the expansion joint of a pressure vessel ends up being thicker than the thickness of the shell tube? ! Could it be that the value chosen is incorrect in this case? Specific parameters: Design pressure of the shell side: 5.5 MPa; Design temperature: 280°C; Material: Q345R. Design pressure of the tube side: 0.1 MPa; Design temperature: 300°C; Material for the tube sheet and heat exchange tubes: S30408; Structure type: Vertical
A question was asked on June 16, and it wasn’t approved and posted until July 9 – what a slow pace! ?