Problems with spiral plate heat exchangers
Thread Content
The material enters from the middle section around the perimeter of the heat exchanger and then exits from below the inner ring. Heat exchange occurs in the lower half of the entire heat exchanger, but there is little effect in the upper half; in other words, only half of the heat exchanger is being utilized. Is there any way to solve this problem?
There are two options in total. The first option is to change the orientation of the device’s connection ports to use upper and lower flanges. The second option is to convert the device from a vertical configuration to a horizontal one. You can send me a private message via WeChat at 13921272663; our company specializes in the production of spiral plate heat exchangers
The pipe outlet position can be changed, as well as the structural design
The material to be heat-exchanged enters from below, while the material after heat exchange exits from above; the external flange connections need to be repositioned!