Thread Content
The chain plate conveyor features a rational design; it uses chains to drive the trough plates in motion in order to transport materials. It offers advantages such as high conveying capacity, low power consumption, minimal wear, and reliable operation. It has been used by many paper mills across the country with excellent results, making it the most ideal conveying equipment at present. The center line of the frame must coincide with the longitudinal center line of the chain conveyor, with a deviation of ≤2 mm. The vertical deviation of rack struts from the installation surface ≤ 2 mm/m. The horizontal length deviation between adjacent supports is ≤ 2 mm, and the lateral levelness deviation of the supports is ≤ 1 mm/m. The deviation of the track from the longitudinal center line of the chain conveyor shall be ≤ 1 mm. Gauge deviation ≤ 2 mm. Track straightness deviation ≤ 1.5 mm/m ； The straightness deviation over the entire length shall be ≤ 5 mm, and the curved sections of the track shall be uniform and smooth. Within the same cross-section, the relative elevation deviation between the two tracks is ≤±2 mm. Welding is allowed on the track, but the joint must be smooth and even, with a lateral deviation of ≤±1mm ； Upward and downward offset deviation ≤ 0.3 mm (only a downward displacement along the direction of chain plate movement is allowed). The motor axis should be parallel to the axis of the reducer’s input shaft, and the pulleys should be in the same plane. The deviation of the axis line of the driving sprocket from the center line of the chain plate conveyor shall be ≤ 1 mm/m ； The deviation of the transverse center between the two sprockets from the center line of the entire machine is ≤ 1 mm. The deviation of the tail wheel axis from being perpendicular to the center line of the chain plate conveyor shall be ≤ 1 mm/m ； The deviation of the transverse center between the two sprockets from the center line of the entire machine is ≤ 1 mm. The horizontal deviation of the tail wheel shaft is ≤1mm/m. The deviation of the center line of the roller shaft on the chain plate from the center line of the conveyor shall be ≤ 1 mm/m. The deviation in the horizontal alignment of the roller shaft installation shall be ≤1mm. The busbars under adjacent rollers should be on the same horizontal level, with the height difference between the busbars under neighboring rollers being ≤1mm.