[Process Engineering Division – Chemical Engineering Software Forum – Daily Question – Questions 03–20]
Thread Content
【Process Engineering Section – Chemical Engineering Software Forum – Daily Question – Questions 03-20】In AutoCAD, which of the following statements about polylines is incorrect? A. It is a composite of arcs and straight lines. B. Polylines that are connected end to end can be merged. C. The width at both ends can only be set when drawing straight lines. Note: Questions are valid only for the day they are posted (3 correct answers, 1 wrong answer; posts containing irrelevant content will be deleted). Reposting old questions in large quantities is considered spamming, and such posts will not earn any points or may receive points on a case-by-case basis. 3
C. The width at both ends can only be set when drawing a straight line