Thread Content
When using the Haochen CAD drawing software to create drawings, different lines are often utilized, and each type of line has its own CAD line width. In such cases, it is necessary to set the line widths. Many people encounter a situation where, as shown in the figure below, the lines marked with PL become hollow even though they are thick; they remain hollow when printed as well. What settings should be used to make these lines solid again? Let me introduce several methods to you! Method 1: Open HaoChen CAD >> open the drawing in which the lines need to be turned back into solid lines >> click on “Tools” in the menu bar >> select “Options”; a dialog box will appear >> uncheck “Apply Solid Filling” under “Display Performance” >> type “re” and press Enter to confirm. Method 2: Open HaoChen CAD >> open the drawing in which the lines need to be turned back into solid lines >> enter the “FILL” command and press Enter to confirm; select “ON” from the options that appear >> then enter “re” and press Enter to confirm. Method 3: First, open HaoChen CAD >> open the drawing in which the lines need to be turned back into solid lines >> enter the “FILLMODE” command and press Enter to confirm; follow the instructions on the command line by entering “1” and pressing Enter again >> enter the “TEXTFILL” command and press Enter to confirm >> finally, enter “re” and press Enter. Method 4: First, open HaoChen CAD >> open the drawing in which the lines need to be turned back into solid lines >> enter the “PLAN” command and press Enter to confirm >> then enter “W” and press Enter to confirm. The above are the solutions for making the four types of PL line widths hollow in the HaoChen CAD drawing software. If you encounter similar problems in the future, you can refer to this tutorial to resolve them. I hope it will be helpful to everyone!