Issue with Aspen Version 11 dynamic simulation not running
Thread Content
This post was last edited by Hidden Pig on 2023-6-15 at 11:58. As soon as the dynamic file is opened, it shows: File loading failed. I still haven’t figured out how to solve this; I hope HaiU can give some advice. Thank you!
Hello, regarding the issue of unable to run dynamic simulations in Aspen version 11, there may be several possible solutions: 1. Verify that the path to the dynamic simulation file is correct: Make sure there are no spaces or special characters in the file path, as this could prevent the file from being read. At the same time, it is also recommended to save the files in directories with English names, so as to avoid some unnecessary problems. 2. Check whether the dynamic simulation files are installed correctly: Please ensure that Aspen Version 11 has been installed properly, as well as that all necessary modules and components have been installed correctly. Additionally, if you used a custom installation option, make sure that the dynamic simulation module has been installed correctly. 3. Try reinstalling Aspen Version 11: If neither of the above methods resolves the issue, you can try reinstalling the Aspen 11 software, making sure that all necessary modules and components are installed correctly. The above are some common solutions; if the problem still persists, it is recommended that you contact Aspen’s official technical support team for further assistance. .
This thing is very difficult to install. The first attempt failed, so I had to pay someone to do it; the second time, after reinstalling the system, I managed to install it myself and it worked fine. .
File access permissions: some software does not allow access to paths under the C drive without administrator privileges