Operation method of fully automatic scraper centrifuge

Thread Content

This post was last edited by Centrifuge--Ding Ling on December 30, 2021, at 16:04. First: Turn on the power; wait until the panel of the electrical cabinet lights up. Then proceed with the centrifuge operating procedures: 1. Operation via the control box; 2. Operation via the touchscreen. Second: Operate the control box to carry out the relevant actions. Turn on the hydraulic pump switch, set it to medium speed, and press the green start button. Start the centrifuge, and wait until the indicator light in the upper left corner turns on before feeding the material. Third: After feeding the material, turn off the medium speed setting and activate the high speed setting to remove liquid. Fourth: Once the liquid removal time is complete, turn off the high speed setting and switch to the low speed setting. Wait for the centrifuge to reach the set speed; once the speed indicator light comes on, proceed with scraping the material. Fifth: When scraping, press the scraper rotation button for three seconds to turn it on, keep it on for 15 seconds, then turn it off for 15 seconds. Press the scraper rotation function for another 2 seconds, turn it on for 15 seconds, turn it off for 15 seconds, and repeat this 4 times. Discharge completed. Sixth: After discharging is complete, reset the scraper, turn off the low speed mode, and shut down the hydraulic station. Centrifugation is complete.