What should be done if the span required for mounting pipe supports on pipes cannot be met? ?
Thread Content
What should be done if the span required for mounting pipe supports on pipes cannot be met? ? A pipe support is needed every time the plastic pipe is less than 1 meter long – how many pipe supports will have to be installed on site? It’s really impossible to meet the requirements; how do you all do it? ? ?
The horizontal pipes are directly covered with angle steel, completely enclosed
To make a cage frame, just place the plastic tube on it
For the structure, it’s sufficient to have supports in place; if this wasn’t taken into account earlier, you’ll be in trouble. I’m not sure about your specific situation – is the span of the ductwork large? If it’s a standard case, you could consider placing an I-beam on top; you can handle the piping yourself or have a structural engineer do it.
Make a truss and place the plastic tube on it.