Regarding the classification of fire hazards, those who know about it please come in
Thread Content
An explosion-proof area has been designated in the vicinity of the hazard source (which is classified as Category A). There is one room in that ordinary factory building located within this explosion-proof area; does this mean that the fire hazard associated with that entire ordinary factory building must also be classified as Category A? ?
Yes, you can take a look at the building codes specifically and then you’ll understand
Does this ordinary factory building have to be classified as Category A? ? ? Which specific provision in the building codes is it? I would appreciate it if someone could advise me
They must all be classified as part of the explosion-proof area
Fire hazard classification and explosion protection classification are two distinct concepts; not all explosion-proof areas fall into Category A or Category B； Similarly, Class A and Class B areas are not necessarily explosion-proof zones. The original poster really needs to understand the regulations thoroughly.
Sir, may I ask how this situation should be classified? ? ? There is a room located in an explosion-proof area, and this room has doors and windows. I would appreciate some guidance on this matter. According to building codes, the fire hazard level is determined based on the most severe category; does that mean that the entire ordinary factory building must be classified as Category A? ?
I don’t know what the actual situation is for you, but generally, there is a distance of 15 meters between Class A facilities and ordinary manufacturers; unless there is an additional Zone 2, they definitely won’t be in close proximity to each other. As for whether it falls into Category A, it depends on whether the area of your room exceeds 5% of the total area of the factory building; moreover, a firewall must be installed to separate your room from the other rooms. Personally, I suggest removing the doors and windows of this room that face the explosion-proof area and replacing them with ones facing a different direction.
The classification of explosion-proof areas is intended to help determine the appropriate explosion-proof rating. The selection of electrical instruments is based on categories A, B, C, D, and E; this classification is determined by the properties of the materials used in the production process, and it has nothing to do with whether the area is classified as an explosion-proof area or not. Wastewater treatment plant, Class V, but there is one room located in the explosion-proof area; the motors and switches in this room must be selected with explosion-proof requirements in mind.
So which category should the fire hazard level of this room be classified as? ?
Refer to the building fire protection design codes to see what materials are present in this room; without this information, it’s impossible to figure it out.