After reinstalling INtouch, everything else is working fine, but the anti-surge control line cannot be displayed – what’s going on?
Thread Content
The computer’s hard drive failed, so it was replaced. After reinstalling INtouch, everything else is working fine, but the anti-surge control signal cannot be displayed. What’s the reason for that?
The black areas in the image are not shown; the first image shows what it looks like under normal conditions
There should be fewer controls and similar elements installed; generally, the historical trend is that there are more controls
Is it possible that certain services in the system backend aren’t running? Check the relevant documentation and start them manually from the backend.
It’s running now, everything else is fine
This is not a historical trend; it is displayed in real time, but it is not a trend
I mean, after it’s running, can the anti-surge control line be displayed?
It cannot be displayed; I am consulting the manufacturer and awaiting a response