Problems with the installation of the level gauge diaphragm
Thread Content
Everyone, what would happen if the high-pressure side of LT hit the highest point of the groove, and the low-pressure side L was placed at the lowest point of the groove? What would happen to the diaphragm itself?
As long as it has no effect on the diaphragm within the maximum operating range of the table
Proper installation must take negative migration into account; if the installation is reversed and migration is not considered, some instruments can have their high and low voltage sides set via software, but the instruments will still display negative values at all times, keeping the system in alarm mode. It has almost no effect on the diaphragm.