Here’s a question to test you—how to measure the pressure of concrete slurry, how to choose the appropriate model, and how to install it. Good answer; a reward of 100 yuan will be given.
Thread Content
This post was last edited by 1111111 on 2017-9-17 at 13:06. Here’s a question to test you — how to determine the pressure of concrete slurry, how to choose the appropriate model, and how to install it. . . . . . 1. Concrete slurry is a mixture of water, sand, gravel, cement, and air. 2. Transported through DN100 pipes, with an operating pressure of ≤0.6 MPa. 3. Question: How should I choose a pressure gauge? 4. Question: How to install a pressure gauge? Good answer! I’ll give you a reward of 100 yuan via Alipay. Good answer! I’ll give you a reward of 100 yuan via Alipay. Good answer! I’ll give you a reward of 100 yuan via Alipay. Trying to trick you? You’re such an idiot {:3_51:}.
Posts can be posted in the Haichuan Reward Hall at http://bbs.hcbbs.com/plugin.php?id=it618_wike:index, with rewards given in the form of Haichuan coins
With the removal of the pressure guide tube, the diaphragm type cannot withstand it – how should one choose? This one. Let me think, give it some time.
I want to earn 100 yuan, but unfortunately I don’t know the answer.
Good morning, let’s test you a bit, good morning, let’s test you a bit, good morning, let’s test you a bit
Those made as clamping diaphragms should be cleaned after use
Based on the principle of target flowmeters, is it possible to achieve measurement?
Weighing types can be used as level gauges; can appropriate methods be employed to measure pressure?
Pressure is measured using an annular pressure tap; however, careful selection of the diaphragm is required
All types of pressure transmitters will get worn out like this:
The last edit to this post was made by huio1983 on 2017-9-18 at 17:04; just take a look at concrete pump trucks – it’s mainly the diaphragm that matters