How to set the analog output of the Daniel S600?
Thread Content
As the title suggests, it supports four channels of analog output. How can the parameters for each output channel be defined? For example, if the first channel is used to output the instantaneous flow rate, how should this be set up?
Damn, this usually uses 485; it should be specified in the manual. If not, call the manufacturer.
For analog output, an IO board is needed, just like with familiar devices.
485 is available, but other systems also need this data, and they require a 4-20mA signal, so…
485 is available, but other systems also need this data, and they require a 4-20mA signal, so…