How does the Yokogawa CS3000 system convert weighing signals into flow rate?
Thread Content
For the CS3000 DCS system, which has signals from weighing modules, I want to convert these weighing signals into instantaneous flow rate signals through configuration – a rough estimate of the flow rate is sufficient; accuracy is not required. How can this be achieved using software configuration? Can it be achieved using an LD differential module? If that doesn’t work, what can be used instead?
Not sure, lift it up and wait for an expert to answer: lol
Do you mean to feed material into the tank and estimate the flow rate based on the tank’s weight? ? ? If that’s the case, LD can be used, but the specific parameters will need to be determined on one’s own. It’s also possible to write a script for this purpose, but it will take some time; for example, the weight before and after a 3-minute sampling interval can be used to make estimates