When using the Rosemount HART475 to calibrate the 3051GP, it keeps displaying Kpa; there is no need to switch the display mode
Thread Content
After connecting and establishing communication between the Emerson handheld controller and the Rosemount 3051GP transmitter, the operation steps are as follows. 1. After turning on the handheld device, select HART. 2. Select Online. 3. Then select Configure. 4. Select Guided Setup. 5. Select basic setup. 6. Select display option. 7. Select eng units. 8. Save it; after successful transmission, the LCD display on the 3051GP will show values in Kpa instead of showing percentages of Kpa back and forth.
The instructions you’ve given aren’t accurate either. Moreover, if I remember correctly, the gauge of the 3051GP displays only pressure by default when it leaves the factory, with no other information shown
Lomon’s transmitter switches between displaying in percentage and Kpa
I really don’t want to argue with you; the 3051GP gauge, as it comes out of the factory, only displays pressure