The Station display of the Honeywell R310 is out of sync
Thread Content
This post was last edited by CHNlyt on 2020-1-21 at 11:24. The SCADA system used in our company is Honeywell R310. Currently, Unit A serves as the main unit while Unit B acts as a backup, and the displays of both units sync properly. When logging into the Station via Machine A, it shows that there is an alarm currently active ； When logging into the Station via Machine B, no alarms are displayed. There was no alarm at the actual site, and the Station display of Machine B was correct.
I found the reason. Embarrassing. Still not serious. 1. The alarms displayed on Station A are alarms from other stations. 2. The Assets assigned to Station1 and Station2 are different. Station1, to which Machine A is logged in, has been assigned to another station. Station2 of Machine B is not configured. The key to solving this issue: go to Configuration > Flex Station > and check whether their assignments are consistent. Serious, careful. ! ! ! !
Speaking of which, Honey’s Assets section has its criticisms; it’s necessary to have it, otherwise error checking cannot be carried out! They have a WeChat group for communication; you can ask your teacher at that time for it.