The for loop in the Yokogawa DCS SFC block runs once per second; how can efficiency be improved? I’ve just started learning*; I hope the seniors here can help me figure things out
Thread Content
_The SFCSW block contains the following code: integer i; for i=1 to 96: BDSET.DT01 = i; next. The above loop takes 1 second to execute, so it will take 96 seconds to complete the entire cycle. How can the efficiency of this loop be improved?
How is that possible? SEBOL language executes outside the scan cycle (unknown to new R6)
It’s CENTUM VP R6; I’m not sure if there are any special statements or configurations required, and I haven’t figured it out yet. A for loop that performs no operations still runs at the same slow speed
It doesn’t seem to be a grammar issue