For the DCS of the Zhongkong JX300, can configuration be done in single-machine mode? And can it be deployed in single-machine mode after successful compilation?
Thread Content
For the DCS of the Zhongkong JX300, can configuration be done in single-machine mode*, and can it be deployed in single-machine mode after successful compilation? The IP address has been set to 128.128.1.130, but it still doesn’t work
Is a simulation dog required to run the simulation in single-machine mode?
In other words, if the JX300 from the central control system is configured and compiled as a stand-alone unit, it cannot be deployed in the real-time monitoring software without an encryption dongle?
Sure, it can be used for two hours even without a dog. Please send any error messages you might see so I can take a look
No dog? Can you still configure it and simulate it?
The problem is solved; just use a router and set its gateway to 128.128.1.1, while setting your own address to 128.128.1.130
What kind of system is it? Normally, this device doesn’t need to go through a router
Could it be that the software versions are different? I’m also on Win10; it works just fine. Moreover, my gateway for connecting to the external internet is definitely different.