What are the causes of failures in magnetostrictive level gauges?
Thread Content
There are fluctuations of less than 10 cm right at this location; there is no interference during holidays, and such issues were not observed during normal production. What could be the reason?
Is it KROHNE’s magnetostrictive type?
This level gauge is great; it can generate straight waves as well as square waves
When we repair watches, we take the watch out of its case and check the same position again to see what’s going on; if the problem persists, it’s usually related to the circuit, the waveguide wire, or the float. If everything is normal, rule out fluctuations in the liquid itself as well as density-related factors. Once those have been ruled out, try using another identical sample to see if the issue reoccurs