Orifice plate flow calculation
Thread Content
Could any expert please explain what SG@Flow condition and base condition mean? Is it density?
What software is this, haha
A orifice plate flow meter is a device for measuring fluid flow; it induces a change in the fluid velocity through an orifice plate installed in the pipeline, and then calculates the flow rate by measuring the pressure difference. As for “SG@Flow condition” and “base condition”, the “SG” here generally refers to specific gravity, which is the ratio of the density of a fluid under specific conditions to the density of a reference substance (usually water). - ****SG@Flow condition**: This refers to the specific gravity of the fluid under actual flow conditions, that is, its specific gravity at the temperature and pressure levels present during the actual flow of the fluid. - ****Base condition**: The basic condition generally refers to the conditions under standard or reference conditions, such as the specific gravity of a fluid at normal temperature and pressure. This parameter is used to convert the actual measured values to standard conditions, so that data from different conditions can be compared. When using orifice plate flowmeters, it is very important to know the fluid density under these conditions, as the calculation of flow rate depends on these parameters. .
Thank you, the explanation was very clear. I love you
InstruCalcSingle
Haha, that’s great; it seems to be a foreign software