Quench ring water distribution test
Thread Content
Could some expert tell me the general steps for the water distribution test of the quench ring after the repair of the vaporization furnace? After establishing a preheated water circulation, I need to observe the water flow – is it necessary to change the flow rate here? Thank you, or let’s discuss it together
First, establish the liquid level in the washing tower and start the quench water pump (it is not necessary to install a filter screen for the quench water filter; the cover of this filter must be tightened). The water flows directly into the lock hopper and then to the slag skimmer. Test at each flow rate of 200/400/600 to check how the quench water is distributed at each flow rate, as well as to identify any leaks
Water is fed into the quench ring directly using the quench water standby pump, without going through the scrubber tower; be sure to clean it thoroughly before doing this
I agree with what was said above; our factory also needs to determine the minimum amount required – the smallest quantity of quench water needed to form a water film