I’d like to ask everyone: how is maintenance carried out on the parts of the gasification furnace system that are prone to wear and erosion, and are these parts replaced regularly?
Thread Content
As the title suggests, I would like to ask everyone: in a gasification furnace system, how is routine monitoring carried out for areas that are prone to wear and erosion, such as the conical sections of lock hoppers and the elbows in the ash water system? Are there any regulations specifying which standards should be followed for replacing such components? Thank you all, experts.
During each maintenance session for a single system, it is necessary to inspect or measure the thickness of the critical components; if they are found to be in poor condition, they are replaced.
It cannot be detected during normal operation; it is generally only checked and measured during shutdown for maintenance. Proper measures should be taken for these vulnerable areas before they are put into use. For example, regarding the problems associated with the graywater elbows, various companies have implemented technical improvements such as thickening the elbows, adding wear-resistant fillers, or modifying the elbows into tees to address these issues.
The overview is very thorough; especially for areas prone to wear and tear, corresponding technical improvements are generally made
First, check for wear and tear every time the vehicle is parked, and address any issues promptly during parking inspections. Secondly, wear-resistant materials such as wear-resistant alloys and ceramics are added, along with reinforcing rings on the outside; this three-layer protection system **reduces the risk of leakage, making it highly unlikely for leakage to occur during the operational life