The reason why the full low-voltage transition segment hotspot cannot be activated is that the hot and cold bypass lines have been shut off
Thread Content
The reason why the full low-temperature shift section cannot reach the desired operating temperature is that the hot and cold bypass lines are closed, resulting in a high steam-to-gas ratio. How can this ratio be reduced, and how can the operating temperature of the first shift section be increased?
It is best to include a flowchart to facilitate the identification of solutions within it; control valves should be included as well
By gradually reducing the amount of steam according to the gas flow rate, as the vapor-to-gas ratio decreases, the temperature will rise again.