【Q&A Question 270】2017.09.28
Thread Content
【Q&A Question 270】September 28, 2017: What are the hazards of low oil level in the oil filler of the new hydrogen generator? (Unless otherwise specified, all questions and answers are based on hydrogenation units.) ) The answers to the daily questions change, and today’s answers are shown in subsequent questions. For management purposes, if you need to view content from a few days ago, please go through the summary post below. 2017 Q&A Summary Thread (updates have started) http://bbs.hcbbs.com/thread-1657793-1-1.html 2017 Daily Question Summary Thread (updates have started) http://bbs.hcbbs.com/thread-1657794-1-1.html 2016 Q&A Summary Thread (updates completed) http://bbs.hcbbs.com/thread-1597792-1-1.html (Source: Haichuan Chemical Industry Forum)
Dry friction of metals generates high temperatures, which can cause the metals to deform and reduce their service life
Dry friction of metals generates high temperatures, which can cause the metals to deform and reduce their service life
Dry friction between metals generates high temperatures, which can cause the metals to deform and reduce their service life. Lubricants can alter the surface structure of the metals, smoothing the friction surfaces and thereby extending their service life.
It may cause the oiler to fail to supply oil or to supply an insufficient amount of oil; dry friction between metals generates high temperatures, which can lead to metal deformation and a shortened service life. Lubricant can alter the surface structure of metals, smoothing the friction surfaces and thereby extending their service life.
Insufficient lubricant leads to overheating of the piston, wear of the bearings, and bearing damage
It will cause low oil pressure and poor lubrication in all moving parts
1. It can easily cause interruptions in the oil supply to the new hydrogen compressor. 2. Gas entering the oil injector tank causes discontinuous oil injection.
Too little lubricant fails to provide adequate lubrication; the temperature of the lubricant rises, scaling accelerates, and the temperature of the components that require lubrication increases as well.