Hydrogenation unit pipelines
Thread Content
In hydrogenation units, what should be done if impurities such as welding slag are present in the pipelines of the reaction system?
How should the dust from filling in new agents be dealt with? Take it to the back route?
How should the dust from filling in new agents be dealt with? Take it to the back route?
Before the device is put into operation for the first time, the pipelines and equipment are purged and blown out
It’s either during the initial startup or during major maintenance periods that the catalyst in our reactor is regenerated
Can’t the large flange at the reactor inlet be removed? Remove the purge
Purging of ordinary pipelines, blasting of large-diameter pipelines
Is this an inevitable requirement after the start of each maintenance work, or does it depend on the specific circumstances?
Our company has also just gone through this phase; we recommend using steam purging. Steam cleaning is very thorough, but the cost is relatively high.
This is the procedure to follow for any work involving open flames; otherwise, you won’t be able to clean it properly