How to remove the gasket from the TG face gasket
Thread Content
Now we need to replace the gasket on the TG face flange. Since the gasket was tightened properly earlier, it’s very difficult to replace it – the gasket won’t come out. Is there any good way to deal with this?
You can try using a screwdriver or needle-nose pliers to gently lift the edge of the gasket, and then slowly remove it. If the gasket is stuck tightly, some penetrant can be sprayed on the contact surface between the gasket and the flange; wait a few minutes for the penetrant to do its job before attempting to remove the gasket. Be careful during operation to avoid damaging the sealing surface of the flange. .
I learned it; the last time I encountered it, it took me a long time to figure it out